Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Are these router stats ok

  • 27-07-2015 1:27pm
    #1
    Myrddin
    Closed Accounts Posts: 33,733 ✭✭✭✭


    I had to move my router there, & had to use a different splitter than the one UPC had installed. The values on the splitters are different, so can anyone tell me if these router stats are ok? (UPC 240Mb)

    6034073


Comments

  • #2
    Dave..M
    Registered Users, Registered Users 2 Posts: 693 ✭✭✭Dave..M


    Myrddin wrote: »
    I had to move my router there, & had to use a different splitter than the one UPC had installed. The values on the splitters are different, so can anyone tell me if these router stats are ok? (UPC 240Mb)

    6034073

    The DS power levels look a bit high (as expected with a splitter) but consistent over the channels which is good, signal to noise looks OK though and upstream power is also fine. Keep an eye on the DS power during the winter as these naturally increase in cold weather (due to increase in resistance of copper) but once it stays below 8 which it should you'll likely not have issues (the spec is +/-8 with 0 being optimal but modern docsis 3 CPE's are less sensitive to this now). You could test without the splitter to see the impact that is having for ref levels (use an F coupler to join the cables) and also ensure any outside joins & splitters are well sealed with self amalgamating tape (u can pick this up in halfords).


  • #3
    Myrddin
    Closed Accounts Posts: 33,733 ✭✭✭✭Myrddin


    Many thanks for the info, will take your advice on board :)


Advertisement