Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Laminate Floor Issue

  • 30-03-2015 1:33pm
    #1
    PGL
    Registered Users, Registered Users 2 Posts: 760 ✭✭✭


    Hi folks

    As part of house extension works back in August I got the builder to remove tiles from the kitchen and replace them with wooden laminate flooring. When the laminate flooring was laid I commented that the floor was very "springy" in one spot in particular, and asked if the floor was levelled before the laminate flooring was laid. I was told the floor was not levelled off and that it was normal for laminate flooring to be "springy". That was the end of that conversation at the time.

    However it has emerged in the past few months that the laminate flooring at the "springy" spot is no longer springy and instead the laminate flooring is warped and becoming uneven at this location, and I'm afraid if it gets worse it will become a trip hazard.

    Do I have a comeback with the builder in this situation? i.e. should he have ensured the floor was levelled off before the laminate floor was laid?

    Many thanks!


Comments

  • #2
    PGL
    Registered Users, Registered Users 2 Posts: 760 ✭✭✭PGL


    does the lack of a response mean I have already answered an obvious question?


  • #3
    slinky2000
    Registered Users, Registered Users 2 Posts: 1,286 ✭✭✭slinky2000


    it could have been the fact the installer didn't leave an expansion space along the edges of the floor and when it expands it has no where to go ??


  • #4
    Carpenter
    Registered Users, Registered Users 2 Posts: 2,683 ✭✭✭Carpenter


    Expansion gap was not big enough and its now hitting the wall remove the skirting board and have a look first before getting on to the builder .


  • #5
    PGL
    Registered Users, Registered Users 2 Posts: 760 ✭✭✭PGL


    Carpenter wrote: »
    Expansion gap was not big enough and its now hitting the wall remove the skirting board and have a look first before getting on to the builder .
    The floor is in the kitchen, with kitchen units installed along opposite walls, so there are no skirting boards. The floor was laid before the kitchen units were fitted, so it would be difficult to see if the expansion gap was big enough.

    Would an uneven surface underneath the laminate flooring cause a problem?


  • #6
    slimjimmc
    Registered Users, Registered Users 2 Posts: 7,786 ✭✭✭slimjimmc


    Depending on how uneven the subfloor is it could cause a problem . Flooring manufacturers usually stipulate how flat the subfloor should be, typically this is in the region of 3mm or 4mm over a 3m length. A 3mm foam underlay is normally laid to allow for this variation.
    A hump in the floor may result in the foam underlay being extra compressed at that point making it feel firmer, a hollow in the floor would feel spongy. I'm not certain but I think laminate will settle a little into hollows and gradually fell less springy. In addition, the foam underlay may compress slightly over time and can feel firmer underfoot.

    Best practice would be to level the subfloor to the manufacturers spec but as this was not done (admitted by the builder) I wonder did the builder double up on the underlay to try accommodate the uneven floor. I don't think this would be considered good practice because it make the floor feel particularly spongy overall.

    If the floor was restricted by the lack of an adequate expansion gap or the weight of the kitchen units I would have expect the floor to feel even more springy as the laminate boards bulge upwards.


  • Advertisement
Advertisement