If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)

Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.

Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Wooden box

JonathanAnon · 2010-10-27 11:58:16

Hi I'm trying to build a small box for holding nuts and bolts... with the bits of wood I have round ... I plan on using some left over pinewood strips for the sides of the box and the inner partitions I have it cut as below, should I glue the pinewood strip to the pinewood shelving or nail it ?

27-10-2010 12:58pm

#1

JonathanAnon

Closed Accounts Posts: 23,718 ✭✭✭✭

Join Date: November 2005

Posts: 23286

Hi I'm trying to build a small box for holding nuts and bolts... with the bits of wood I have round ... I plan on using some left over pinewood strips for the sides of the box and the inner partitions

I have it cut as below, should I glue the pinewood strip to the pinewood shelving or nail it ?

0

Comments

#2 29-10-2010 2:55pm

William Powell

Closed Accounts Posts: 1,479 ✭✭✭

Join Date: September 2010

Posts: 1432

If in doubt "glue and screw".

I'd use 3.5x40mm screws (pre drill) dab on the glue screw up and wipe off the excess, job done. If you clamp the base which is quite thick to a bench then you can get the bottom edges level by holding the strip wood flat with the bench as you put in the first couple of screws if you get what I mean.

0