Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Ideal Mini S24 queries

  • 17-06-2014 11:57pm
    #1
    Registered Users, Registered Users 2 Posts: 919 ✭✭✭


    Hi all,

    I use our heating an Ideal Mini S24 during the summer to heat water for showers etc by turning down the stats on the zone valves and opening the heating loop on the cylinder fully. I notice that the boiler runs up to temp stops for about 3 mins and then fires again for 60 - 90 secs.

    These seems a little too frequent for me. I found the manual and am thinking of upping the anticycling timeout. Should I do it? If so what time should I set it too?

    The old analogue timer failed last year and I replaced it with a Siemens RWB29 with CH and HW timers. I've only wired it to run CH but the live feed for the stats is fed to the boiler so am wondering if its possible to wire it to control both? It's a pain if someone turns up a stat and then there's no hot water in the morning. I've a switched live for the boiler, circulating pump and stats.

    Thanks in advance!


Comments

  • Registered Users, Registered Users 2 Posts: 919 ✭✭✭n0brain3r


    So I set the anti cycle time to 5 minutes by this time the water returning has dropped to 40C and I set the boiler to cut out at 75C now it runs for about 10 mins before reaching temp. Does this sound ok?

    Any ideas on controlling CH and HW?


Advertisement