If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)

Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Fitting flashing led to SAB box.

degsie · 2014-12-17 18:00:56

Thinking of adding a flashing led board to this sab board as the red on-board led is very dim :(. Looking at the following: http://www.amazon.co.uk/White-Flasher-battery-Dummy-Security/dp/B00E5IC290 How would I best connect the led pcb to the SAB board so its permanently powered? Note says it needs 3.6V to 12V DC. Thanks.

Options

17-12-2014 7:00pm

#1

degsie

Registered Users Posts: 8,740 ✭✭✭

Join Date: January 2004

Posts: 8101

Thinking of adding a flashing led board to this sab board as the red on-board led is very dim .

Looking at the following:
http://www.amazon.co.uk/White-Flasher-battery-Dummy-Security/dp/B00E5IC290

How would I best connect the led pcb to the SAB board so its permanently powered? Note says it needs 3.6V to 12V DC. Thanks.

0

Comments

Options
#2 17-12-2014 7:38pm
fred funk }{

Registered Users Posts: 6,827 ✭✭✭

Join Date: January 2005

Posts: 6638

Your external + and the hold off - are your perminent power. Bare in mind that the panel normally outputs 13.5 vdc and might be at the upper end of what your LED fitting might be able to handle.

0