Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Skirting on wooden floor

  • 16-08-2013 4:01pm
    #1
    Registered Users, Registered Users 2 Posts: 3,609 ✭✭✭


    Is there a good way of profiling skirting to match wooden flooring to prevent the odd gap between the floor and skirting, especially on long walls.
    I want to avoid the beading that is used, and I hate the way that wooden floors may not perfectly level along the entire length of skirting.
    Has anyone got a method of planing and profiling skirting to match the subtle contours of the floor?


Comments

  • Registered Users Posts: 74 ✭✭chinchin


    Hate those gaps too, not the answer you were looking for but, I've used decorators caulk before to fill the gap and then paint the skirting, looks perfect if done well.


  • Registered Users, Registered Users 2 Posts: 4,255 ✭✭✭tommy2bad


    Cauk is about it, the trouble with profiling the skirt to the floor is that the floor will change a bit over time and all your efforts will be for naught.


  • Registered Users, Registered Users 2 Posts: 439 ✭✭North West


    Hi Stoneill
    Most timber you buy has a % moisture content in it. That is why some skirting do not fit good, because the timber will shrink slightly leaving a gap. I usually cut the skirting and pin them up for a few weeks and then return and fix properly. If the boards are slightly warped I put a piece of board on top of the skirting and kneel on it to push to floor and then fix.
    NW


  • Registered Users, Registered Users 2 Posts: 1,444 ✭✭✭sky6


    The proper way to profile the skirting is to scribe the skirting with a pencil which will show the high and low points. Then using a plane plane it to fit.
    It can be slow and tedious if you have a few to do but worth the effort as you will be looking at it for a long time.


  • Registered Users, Registered Users 2 Posts: 3,609 ✭✭✭stoneill


    Thanks for the replies - I think I'll be trying the pencil/plane method.


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 1,946 ✭✭✭whizbang


    I used draught sealing strip. (mostly was 5mm gaps).
    Anymore than that, I found, by putting a long plank end on the skirting and standing on it, I could bend the skirting down to fit the profile of the floor.


Advertisement