Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Error code of Zanussi washing machine

  • 19-08-2011 8:21pm
    #1
    daigo75
    Registered Users, Registered Users 2 Posts: 389 ✭✭


    Hi all,
    My washing machine (Zanussi ZWF12070S) recently decided to stop washing half way through, and I'm trying to figure out what's wrong. When the issue occurs, the Start/Pause button flashes red; if I turn the knob to Off and then to any other program, the machine starts, just to stop again after a while (roughly in the Rinse phase).
    Having the laundry soaked in water, I tried to just do the "Rinse", and it stopped; I then tried to just run the "Spin" program, and it worked correctly.

    At the moment I checked filters and drain, nothing seems to be blocked. I unplugged it for a bit of time and retried, to no avail. After a bit of research, I managed to find an error code, which should be E11 (button flashes Green once, then Red once). This, in my understanding, could mean "problem filling", but I'm not sure where I should start looking. There's plenty of pressure in the pipes (tested), is there anything else I could do before calling someone to service it?

    Thanks for the help.
    Tagged:


Comments

  • #2
    knighted_1
    Closed Accounts Posts: 870 ✭✭✭knighted_1


    its one of the two solenoids -


  • #3
    daigo75
    Registered Users, Registered Users 2 Posts: 389 ✭✭daigo75


    Thanks Knighted.
    Actually, it was something much simpler: not enough water coming into the washing machine. The issue was that, since our water supply is not very clean, a lot of dirt accumulated in the intake and it was clogging it. A bit of time and patience did the trick, I removed a good spoon of mud and everything works fine. :)


  • #4
    knighted_1
    Closed Accounts Posts: 870 ✭✭✭knighted_1


    knighted_1 wrote: »
    its one of the two solenoids -

    the intake is the solenoid , it splits into two inside the machine ,so the solenoid was blocked - :)


    E11 = Problems with water fill in wash phase (maximum 10 minutes for each fill phase). Possible causes = 1: Tap closed 2: Mains water pressure insufficient 3: Solenoid valve 4: Hydraulic circuit of pressure switches 5: Pressure switches 6: Wiring 7: Main PCB


  • #5
    daigo75
    Registered Users, Registered Users 2 Posts: 389 ✭✭daigo75


    I must have misunderstood, then. So you were right! :) Thanks for your help.


Advertisement