[eirator]

Originally Posted by hecklehim

This afternoon I went out and bought an Edimax Universal Wi-Fi Extender EW-7438RPn and all my problems have been solved. Super easy setup and so far everything is looking good.

Home plugs can be another simple solution. 3G Router > Ethernet cable > Home Plug > House wireing > Home Plug > Ethernet cable> computer. You can even plug a wireless router in place of the computer to go back to a wireless conection.

[itu]

hi
i have dovado umr, i upgraded the firmware and the it is bo longer responding. i cannot access the webpage when i dial the ip :192.168.0.1
please help

[eirator]

Originally Posted by itu

hi
i have dovado umr, i upgraded the firmware and the it is bo longer responding. i cannot access the webpage when i dial the ip :192.168.0.1
please help

Whats the IP address of the computer you are using to connect from?

[itu]

I made the ip for my computer : 192.168.0.2

[eirator]

Originally Posted by itu

I made the ip for my computer : 192.168.0.2

Fair enough - I was just checking the obvious

[Commsoft]

Originally Posted by itu

hi
i have dovado umr, i upgraded the firmware and the it is bo longer responding. i cannot access the webpage when i dial the ip :192.168.0.1
please help

If the factory reset* doesn't resolve it, you'll need to try the Rescue utility which can be downloaded at http://commsoft.ie/download/Dovado.UMR.Rescue.exe

*To reset, power on the UMR without a modem installed and then press and hold the reset button (inset at the back) with a small screwdriver or similar implement for 8secs and then release.

Regards

Gerry, Commsoft Ltd

[itu]

commsoft thank you for that advice but it didn't work.
i tried resetting it nothing happens the led for wan,wifi and power are on.
i also downloaded the rescue software but its says my local ip settings are wrong.
bit i am sure my ip is 192.168.0.2

[itu]

the WIFI LED becames on instantly as i insert power

[itu]

now it says "error in file upload: a connection attempt failed because the connected party did not properly respond after a period of time, or established a connection failed because connected has failed to respond

[Commsoft]

Originally Posted by itu

commsoft thank you for that advice but it didn't work.
i tried resetting it nothing happens the led for wan,wifi and power are on.
i also downloaded the rescue software but its says my local ip settings are wrong.
bit i am sure my ip is 192.168.0.2

To make the Rescue utility work you must connect to the UMR via ethernet cable and setup your PC's LAN connection with a static IP address of 192.168.1.2 - follow the instructions on the Rescue utility thereafter. Fingers crossed.

Gerry, Commsoft Ltd