Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all,
Vanilla are planning an update to the site on April 24th (next Wednesday). It is a major PHP8 update which is expected to boost performance across the site. The site will be down from 7pm and it is expected to take about an hour to complete. We appreciate your patience during the update.
Thanks all.

MF 290 engine seized

  • 14-03-2019 1:24am
    #1
    samjames
    Registered Users Posts: 213 ✭✭


    seized badly and only sitting 5 months but took injectors out and poured diesel into them, seems 2 will fill up and remain full but the other 2 will not hold the diesel so is that a good thing or bad thing


Comments

  • #2
    mad-for-tar
    Registered Users Posts: 168 ✭✭mad-for-tar


    Doesn’t look good to start with. What way was it running before it was parked up a few months ago? Will it bar over by hand? (Remove starter motor and use a pry bar on the teeth of ring gear to try lever it round).
    Does it look like you might be able to do compression test on it? (Provided it can turn over by hand).

    If it can’t be moved at all, then I’d say it’s head off first to have a look and depending on how bad things are, sump will have to come off too, might have to consider pulling engine out and sending off t an engine shop to have it looked at. The 248 Perkins was never as good as its 236 counterpart.


  • #3
    samjames
    Registered Users Posts: 213 ✭✭samjames


    the engine was done up 8 years ago and the exhaust was covered so dont know why its got so tight, have used a bar but it stuck hard

    why 2 injectors holding diesel and 2 not?


  • #4
    CJhaughey
    Registered Users Posts: 14,906 ✭✭✭✭CJhaughey


    Water in fuel will cause extensive damage to the fuel system- Pump and injectors.
    Is there an inline water trap/filter? Is it clean and not full of water?


  • #5
    selfdiy
    Registered Users Posts: 182 ✭✭selfdiy


    Wouldn't worry too much about it not holding diesel, could be just running down between the ring gaps.

    There could be rust formed in the cylinder walls. Try rocking it over and back while its in gear.

    Or a very gentle tow start to see if you can get it moving.


Advertisement