Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Hi all,
Vanilla are planning an update to the site on April 24th (next Wednesday). It is a major PHP8 update which is expected to boost performance across the site. The site will be down from 7pm and it is expected to take about an hour to complete. We appreciate your patience during the update.
Thanks all.

Peugeot 405 (93) Headlight/dip problem

  • 03-11-2012 9:48am
    #1
    NwRepairman
    Registered Users Posts: 44 ✭


    Hi all,
    having a problem with my dipped lights in my wonderful 405. :p

    Full beams are spot on - dips are brutal. Two fireflies in a jam jar would be better.

    New Bosch bulbs gone in just in case and no change.
    From what i've researched it sounds like it could be the dip/lights relay?
    Am i correct in thinking as you look out over the bonnet from the wheel, these relays are in a black aquare box on the right hand side?!

    Anyone any experience with these?

    Any advice greatly appreciated folks, thanks.


Comments

  • #2
    Row
    Registered Users Posts: 2,025 ✭✭✭Row


    pm/post the chassis number and i'll see what i can find...:)
    also make sure all earths are good.


  • #3
    Row
    Registered Users Posts: 2,025 ✭✭✭Row


    O.k...i have attached a few electrical drawings of the low/main beam lights on a 405...:)
    The low/main beam relays are in around the bulkhead area..See 2400A &
    2400B in diagram 2...these are the relays you need to check.
    maybe swap them around and see if the fault goes from the low beam to the high beam.


Advertisement