Triton T90SR cutting out

khaldrogo

Hi. My shower has started to cut off after a few minutes.

The power light goes dim for about 2 minutes and then gets bright again and then the shower will work again.

I had to replace the solenoid on my last triton due to loss of water pressure.

Any ideas how to fix this?

Thanks

Bawnmore

Not sure if it'll be any help or not, but ours was going dim intermittently recently and not powering on. It was an issue with the cabling not being terminated at the isolation switch, burnt out a little and wasn't getting the full power it needed some of the time. Needed to be re-terminated and all fine since.

John.G

Pull cord isolators often cause this sort of issue.

khaldrogo

https://www.boards.ie/discussion/comment/123999729#Comment_123999729

I did have to replace the pull cord a few years ago. Might try a new one and cross the fingers