Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Water leak Limerick

  • 07-06-2025 01:41PM
    #1
    Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭


    Hi,

    Anyone can recommend water leak detection service based in Limerick? I see a circular wet spot on the ceiling, just below the bathroom.

    Thanks



Comments

  • Registered Users, Registered Users 2 Posts: 298 ✭✭Souness


    If it's below your shower could be just silicone seal needs redoing, had similar stain and digging out old seal and replacing fixed it.



  • Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭masterboy123


    Oh right.

    I did new silicon around the rectangular shower tray base. It's more so underneath the shower drainage.

    Can you share a YouTube video please?



  • Registered Users, Registered Users 2 Posts: 26,041 ✭✭✭✭phog


    Get something like this to remove the old silicone first, then dry the area or leave to dry and reapply fresh silicone

    Edit to add a YouTube Clip

    Second Edit to add - If your ceiling has a water stain then you may need to use a Stain Block Paint on it before repainting the ceiling



  • Registered Users, Registered Users 2 Posts: 1,133 ✭✭✭Louche Lad


    Or could even be the grouting between the tiles in the wall has decayed, letting water in through fissures. I had that once, and regrouting fixed it.



  • Registered Users, Registered Users 2 Posts: 2,925 ✭✭✭Hooked


    Could be any number of things… I've dealt with anything from failed silicone causing excess water to run down the back of the tray… to water from a leaky tap compression fitting tracking all the way along the pipe until it dripped at a bend (above a wet patch), to mates gaff where the waste pipe had completely come away from the fitting.

    If you are any way confident at all - and own basic tools - you could cut away a small section of the plasterboard and lash a torch up there to investigate.

    But before any of that - I'd be checking the usual tap and waste connections in the bathroom. And try the cheapest fox first - re- silicone where the tile/wall meets the tray.



  • Advertisement
  • Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭masterboy123


    From the tape measurements, the location just above the stain is the water drainage area in the shower tray. There is a circular stain mimicking the water drainage area.



  • Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭masterboy123


    Could there be a silicon ring in the water drainage area of the shower tray? That's where the stain is.



  • Registered Users, Registered Users 2 Posts: 298 ✭✭Souness


    The stain will appear under the the waste outlet/shower drain in most instances as there is a hole cut in floor under waste outlet to allow pipe through. The water is getting under the tray and making it's way to the hole in the marine ply. Takes a long time for ceiling to dry, when did you do the silicone replacement?



  • Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭masterboy123


    So do you think the issue is with the silicone between the shower tray and the wall? We replaced this silicone about 6-8 months ago and got the anti-mould silicone from screwfix. I have the tools to re-do but I feel the issue is with the shower drainage due to its location.

    I will attach a picture.



  • Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭masterboy123


    I attaching the picture of the ceiling.

    1000105171.jpg


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 3,319 ✭✭✭naughtysmurf


    is your shower tray in the middle of the room or have you quite a large tray?



  • Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭masterboy123


    Shower tray is on the first floor in the corner of the bathroom. Usual size, not a large one.



  • Registered Users, Registered Users 2 Posts: 3,319 ✭✭✭naughtysmurf


    I’d probably cut a hole out of the plasterboard where the stain is, big enough for a look, not too difficult & easy to repair afterwards, run water down the shower waste pipe only, keeping it away from the walls, to rule stuff in or out

    Grout is water resistant not proof & if wall & tray are not siliconed probably that will lead to issues, I’d say there isn’t a shower in the country that hasn’t leaked at some point, whatever the issue is with installing them & as mentioned water can travel some distance from the issue before it makes itself known



  • Registered Users, Registered Users 2 Posts: 26,041 ✭✭✭✭phog


    The water stain could me miles away from the actual source of the water, it depends on what path the water takes from the "leak"

    The easiest thing to rule out now is the silicone around the tiles & shower tray. That's where I'd start then cross my fingers it's a success



  • Registered Users, Registered Users 2 Posts: 298 ✭✭Souness


    It's the most likely culprit as with movement over time it fails but as you redid it over six months ago and stain is not drying out may not be. If it was the drain I'd expect a bigger stain considering the volume of water passing through it. As someone else said could be gap in the grout letting water behind the tiles.



  • Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭masterboy123


    Thanks all.

    When I redid the silicone about six months ago, there was no issue at all. The stain appeared three days ago.

    I will redo the silicone this week and hope for the best.



  • Registered Users, Registered Users 2 Posts: 2,925 ✭✭✭Hooked


    Failing that - cut a small hole in the plasterboard, and get a look up there. It's easily repaired.



  • Registered Users, Registered Users 2 Posts: 6,162 ✭✭✭masterboy123


    I just finished partially removing the existing silicone. Water (maybe 50–100 ml) flowed out when I punctured it. It seems water seeped behind the silicone. Removing the silicone was very difficult, despite using a tool and silicone remover from Screwfix. I will leave it like this for two days to let it all dry and then apply the new silicone on Friday.



Advertisement