Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Mira Elite QT faulty help/ advice needed

  • 26-08-2024 3:46pm
    #1
    Registered Users, Registered Users 2 Posts: 190 ✭✭


    Any advice, our Mira Elite QT stopped working mid use, and has since sounded like it is working as normal but no water is exiting the shower head!! I replaced the solenoid thinking that was it, it is still the same. The new solenoid has 5ohm and the old one has 4ohm, so I can't see an issue with that. It sounds like the pump is working just not pushing water out! Any idea/ help would be a great help, please. I have a video of it but can't post here for some reason!!



Comments

  • Registered Users, Registered Users 2 Posts: 3,623 ✭✭✭John.G


    Think you can check the inlet filter in those without isolating the water, just remove the filter cover, check/clean the filter then put your finger in and push the flap until water comes out, replace filter. Also ensure CWSC full of warer!

    You mean 4k/5k ohm coil resistance??



  • Registered Users, Registered Users 2 Posts: 190 ✭✭madmaxvideo


    Yea I have done that, water passing when I press the water release button in the filter space. Still no joy. Only other thing I noted was a good bit of black(soot) dust inside. Installed approximately 4 years agó.

    Sorry, yes 4k/ 5k ohm resistance.



  • Registered Users, Registered Users 2 Posts: 3,623 ✭✭✭John.G


    If the shower is "noisy" then suggests pump is running, have you removed the hose from the shower? and keep turning the temperature control from fully cold to fully hot.



  • Registered Users, Registered Users 2 Posts: 190 ✭✭madmaxvideo


    Just for an update, the pump elbow had a cracked clamp, no water leak but must have been enough to allow air in. I had the cover off, ran it for a few seconds, it ran as normal and leaked water from the failed elbow clamp, replaced full elbow and clamps, now all working as it should! Thanks for any help offered!



Advertisement