Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on [email protected] for help. Thanks :)
Private profiles - please note that profiles marked as private will soon be public. This will facilitate moderation so mods can view users' warning histories. All of your posts across the site will appear on your profile page (including PI, RI). Groups posts will remain private except to users who have access to the same Groups as you. Thread here
Some important site news, please read here. Thanks!

Mapping/drawing farm

  • 17-10-2021 6:45pm
    #1
    Registered Users Posts: 1,016 ✭✭✭ L1985


    Hi all.been away for a good while from this as got busy but back with a question for ye!

    I want to look at mapping my farm-what I mean by that is have the full farmyard drawn out and having al the measurements ,water pipes layout ,drainage on it that I can check up and see. We have two separate water systems and a fair bit of drainage but even having all the sheds measurements and gaps would be worthwhile I think. I’ve no head for remembering the width of sheds etc and a lot of the pipes were put in before I was born so could get dad to show me and record it. I’d want it on some sort of app…. Doing a fair bit of work over the next couple of years and if I had this done it would be done for good.

    Any ideas? I also hope I’m explaining it correctly:)



Comments

  • Registered Users Posts: 5,921 ✭✭✭ MrMusician18


    AutoCAD web. It's free at the moment.



  • Registered Users Posts: 3,307 ✭✭✭ Hard Knocks


    I’ve used Adobe Acrobat, it’d be a good idea when you’re done to get a map printed



  • Registered Users Posts: 1,016 ✭✭✭ L1985


    I’ve just signed up for autocad there so I’ll see how I go. It’s only a free seven day trial however so wouldn’t be able to access or change it afterwards I’d imagine…

    I’ll have a look at Adobe (I can print it out) but usually when I need this info it’s very handy to have it on the phone although I could just save or email it to myself either!



  • Registered Users Posts: 31 farm to fork


    You can use Tinkercad or Onshape both are online platforms.



Advertisement