Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Help replacing 2014 Honda Civic driver's side rear tail light

  • 14-05-2019 12:53pm
    #1
    naughtysmurf
    Registered Users, Registered Users 2 Posts: 3,292 ✭✭✭


    I have a used replacement , there is only a couple of screws holding original, cable harness then goes into the body of car through a rubber grommet/connector combination, harness continues on for 20cm to a white 5 way connector

    Thought once removing grommet the rest of harness would follow but the harness seems secured, any ideas?

    I could cut & solder wiring but hoping to avoid



    Thanks


Comments

  • #2
    CJhaughey
    Registered Users, Registered Users 2 Posts: 14,907 ✭✭✭✭CJhaughey


    naughtysmurf wrote: »
    I have a used replacement , there is only a couple of screws holding original, cable harness then goes into the body of car through a rubber grommet/connector combination, harness continues on for 20cm to a white 5 way connector

    Thought once removing grommet the rest of harness would follow but the harness seems secured, any ideas?

    I could cut & solder wiring but hoping to avoid



    Thanks
    Pull the body panel away from that side and you should see any cable clips that might be securing the subloom.


  • #3
    naughtysmurf
    Registered Users, Registered Users 2 Posts: 3,292 ✭✭✭naughtysmurf


    Had a quick look at doing that but couldn't see anything obvious, fixings etc in order to remove the interior panel in the boot, in that corner is the little cuby hole for the tyre inflator kit, will have another look over the next day or two, quite tempted to just leave the original harness in, cut the wires & join to new tail light wiring, it's colour coded so straight forward enough


Advertisement