Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Changing rads - Sizes

  • 16-11-2018 8:42pm
    #1
    gutteruu
    Registered Users, Registered Users 2 Posts: 1,061 ✭✭✭


    I have a rad where the incoming pipe is hot but rad doesn't heat. I am guessing the rad is blocked with gunk or valve. I've tried tapping the incoming and outgoing valves in case that's the problem to no avail. I cannot bleed it as bleed screw head is rung. As I can't bleed it, I'm assuming I can't reinstall it so I need to replace. So......

    If I do replace, I can't seem to see a standard size online. Its length is 1280mm. I can't see anything remotely close on any site. Its all standard sizes in 100mm increments. Its a standard 15 year old rad. I see screwfix do extension pieces. Is this normal?

    Any ideas?


Comments

  • #2
    John.G
    Registered Users, Registered Users 2 Posts: 3,623 ✭✭✭John.G


    gutteruu wrote: »
    I have a rad where the incoming pipe is hot but rad doesn't heat. I am guessing the rad is blocked with gunk or valve. I've tried tapping the incoming and outgoing valves in case that's the problem to no avail. I cannot bleed it as bleed screw head is rung. As I can't bleed it, I'm assuming I can't reinstall it so I need to replace. So......

    If I do replace, I can't seem to see a standard size online. Its length is 1280mm. I can't see anything remotely close on any site. Its all standard sizes in 100mm increments. Its a standard 15 year old rad. I see screwfix do extension pieces. Is this normal?

    Any ideas?

    I think Quinns do 1250 MM rads?, if so then you are only extending the telescopic tail pieces by 15 mm on each side, if a 1300 mm rad will physically fit then the tail pieces will extend "too far" by 10 MM (less than 1/2") on either side, after attaching one side you (or your plumber) may be able to slide the rad fractionally to one side to enable to get the other pipe attached and then center up the rad, a lot will depend on the 1/2 ins pipework whether done in copper or not.


Advertisement