Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

1056xl wont move forward or reverse

  • 29-06-2017 10:09am
    #1
    case1056xl
    Registered Users, Registered Users 2 Posts: 3 ✭


    hi everyone i changed d brake piston seals in my case 1056xl last nite when finished i went to pull her out of d garage when it would not move,it will select gears fine and when i leave my leg off clutch fully nothing happens.any one have any ideas what cud be wrong


Comments

  • #2
    kay 9
    Registered Users, Registered Users 2 Posts: 2,676 ✭✭✭kay 9


    case1056xl wrote: »
    hi everyone i changed d brake piston seals in my case 1056xl last nite when finished i went to pull her out of d garage when it would not move,it will select gears fine and when i leave my leg off clutch fully nothing happens.any one have any ideas what cud be wrong

    Clutch cable, release bearing maybe. How was the clutch whilst it was working, much wear?


  • #3
    patsy_mccabe
    Registered Users, Registered Users 2 Posts: 11,127 ✭✭✭✭patsy_mccabe


    Have you knocked one of the other gear sticks into neutral, by any chance?


  • #4
    case1056xl
    Registered Users, Registered Users 2 Posts: 3 ✭case1056xl


    All gears seem to select fine never had problem with the clutch.i removed the left hand half housing replaced seals and put every thing back together,then shifted the tractor to get at right side half housing replaced seals on brake piston put everything back together went to move tractor and no movement even when tractor is in gear and foot left of clutch.anyone any ideas??


  • #5
    patsy_mccabe
    Registered Users, Registered Users 2 Posts: 11,127 ✭✭✭✭patsy_mccabe


    I remember when I did the brake liners on my David Brown 995 I had to tie down the diff lock pedal before removing the final drives. I was told to do this by an experienced mechanic.


  • #6
    case956tom
    Registered Users, Registered Users 2 Posts: 180 ✭✭case956tom


    case1056xl wrote: »
    hi everyone i changed d brake piston seals in my case 1056xl last nite when finished i went to pull her out of d garage when it would not move,it will select gears fine and when i leave my leg off clutch fully nothing happens.any one have any ideas what cud be wrong
    when you put it in gear does it pull back the engine when you release the clutch?did you check the gear lever on the r/h side by the seat? it may have been pushed into neutral.


  • Advertisement
  • #7
    Bullocks
    Registered Users, Registered Users 2 Posts: 5,891 ✭✭✭Bullocks


    I'd be with a few other replies . Did you definitely check that the splitter is properly in gear ?


  • #8
    case1056xl
    Registered Users, Registered Users 2 Posts: 3 ✭case1056xl


    All sorted and thanks for d help all that happened was when i jacked d cab i pushed d crawler lever out of gear,thanks for d help no doubt ill be on again


Advertisement