Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Pull through teat.

  • 28-02-2017 6:19pm
    #1
    satstheway
    Registered Users, Registered Users 2 Posts: 831 ✭✭✭


    I have jfc pull through teats here. Black pointy ones. Are the holes supposed to be 20mm or 22mm


Comments

  • #2
    satstheway
    Registered Users, Registered Users 2 Posts: 831 ✭✭✭satstheway


    satstheway wrote: »
    I have jfc pull through teats here. Black pointy ones. Are the holes supposed to be 20mm or 22mm

    Its 20mm


  • #3
    PMU
    Registered Users, Registered Users 2 Posts: 633 ✭✭✭PMU


    is there an easy way to get on new teats


  • #4
    Buford T. Justice XIX
    Closed Accounts Posts: 20,633 ✭✭✭✭Buford T. Justice XIX


    PMU wrote: »
    is there an easy way to get on new teats
    Push them through until they are 5-6mm from being flush, then catch the outside and pull up until the bottom clicks out and then pull down until the top clicks out and they're done.

    Getting them out is a bit trickier though.


  • #5
    visatorro
    Registered Users, Registered Users 2 Posts: 3,554 ✭✭✭visatorro


    I used a plumbers pliers, can be slippery when wet!


  • #6
    davidk1394
    Registered Users, Registered Users 2 Posts: 4,221 ✭✭✭davidk1394


    Needle nose pliers is good to do the trick.


  • Advertisement
  • #7
    Sam Kade
    Registered Users, Registered Users 2 Posts: 12,313 ✭✭✭✭Sam Kade


    Buford T. Justice V wrote: »
    Push them through until they are 5-6mm from being flush, then catch the outside and pull up until the bottom clicks out and then pull down until the top clicks out and they're done.

    Getting them out is a bit trickier though.
    To get them out I use a stanley knife and cut them at the outside.


  • #8
    satstheway
    Registered Users, Registered Users 2 Posts: 831 ✭✭✭satstheway


    Any ideas for fixing a bucket that was drilled with 22mm holes.

    Are the peach teat 22mm size?


Advertisement