Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Wardrobe hinge repair

  • 10-02-2017 12:35pm
    #1
    Registered Users, Registered Users 2 Posts: 6,908 ✭✭✭


    In moving a wardrobe into the upstairs bedroom of our house, we managed to pull two of the hinges out of the side panel.

    What would be the best way to repair these? The hinges are flush mounted into the doors so it wouldn't be easy to make up new openings for them and the chip board has pulled away where the screws are so not sure if I could glue them. I was thinking about adding longer screws but the outside of the wardrobe is visible so don't want it to look terrible.

    408873.jpg

    408874.jpg

    Sorry for the poor images, they looked a lot clearer on my phone.

    Any ideas?


Comments

  • Registered Users, Registered Users 2 Posts: 2,376 ✭✭✭jack of all


    Easiest way would be to patch/fill the damaged area with a good car body filler (isopon or similar), which can be sanded and drilled when dry, should be strong as the original particle board if carefully done.


  • Registered Users, Registered Users 2 Posts: 405 ✭✭hawkeye_bmr


    You could use 2 counter sunk bolts on the outer panel, then washers and nuts on the inner hinge part.

    Then a few screw cover stickers to hide the bolt heads.

    Not ideal as the bolt could pull through as you're lessening the thickness of the board slightly by countersinking.

    The only outer option is to relocate the hinge by 100mm up or down.
    I've just done this to a kitchen door, using nothing more than a dremel. Worked a treat!


  • Registered Users, Registered Users 2 Posts: 73,520 ✭✭✭✭colm_mcm


    Drill new holes in the hinges themselves.


  • Registered Users, Registered Users 2 Posts: 6,908 ✭✭✭Alkers


    Went with the isopon method which worked a treat. Didn't have a dremel or that would.have been a good option alright.


  • Registered Users, Registered Users 2 Posts: 2,298 ✭✭✭martinr5232


    Simona1986 wrote:
    Went with the isopon method which worked a treat. Didn't have a dremel or that would.have been a good option alright.


    Tec 7 would be a better job


  • Advertisement
Advertisement