Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

fixie chain alignment

  • 15-02-2016 2:14pm
    #1
    Registered Users, Registered Users 2 Posts: 1,474 ✭✭✭


    hi,
    the other half got a fixie last year & the rear wheel hub is proving pretty difficult to adjust & align the wheel straight, there is an alignment tool on the gear side but and the wheel tends to slip when tightening up the hub,

    should there be 2 adjusters, like one on each side, like a motor bike would have ??????


Comments

  • Registered Users, Registered Users 2 Posts: 25,038 ✭✭✭✭Wishbone Ash


    Can you over do the non drive side and then use the adjuster and leverage on the wheel to bring it into line?


  • Closed Accounts Posts: 6,450 ✭✭✭Harrybelafonte


    Would this work? Hold wheel so that chain is taught but not too tight and wheel is centred. Tighten one side until it's jus more than hand tight and then tighten the other side all the way. Go back to other side and tighten properly

    Should work, though I may be misunderstanding the issue.


  • Closed Accounts Posts: 6,450 ✭✭✭Harrybelafonte


    Fixed gear bikes generally don't have tensioners tbh. They tend to cause more hassle than not.


  • Closed Accounts Posts: 6,450 ✭✭✭Harrybelafonte


    Also. Sometimes shoving a tea towel inbetween wheel and seat tube can help keep it in place when tightening.


  • Moderators, Sports Moderators Posts: 25,530 Mod ✭✭✭✭CramCycle


    There should be no need for adjusters unless the dropouts are poor quality.

    You can buy them cheaply enough, amazon usually have them or think I seen them on SJS before.

    Stretch and overtighten on one side, then pull the wheel as much as possible to the untightened side, and tighten as much as you can. Loosen the first side sklightly and try and hold the wheel in the centre and retighten.

    May take a few tries.


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 1,474 ✭✭✭Notch000


    Got it sorted now, a second person and a couple of washers held wheel straight, looks like the cuct out things don't line up too square.


Advertisement