Servis Dishwasher Won't Drain - Model M2010INT

GPBUTLER

Hi,

I have an integrated Servis dishwasher, Model M4010INT.
It alarms/beeps after the firsd a rinse cycle t rinse cycle of a program, at the drain step - 10 beeps approx every 30 seconds and lights 1, 3, 4 constantly flash (left to right).
Water is sitting in the end of the dishwasher and no other programs can be selected while in the alarm state.
I disconnected the drain from the sink drain inlet and managed to drain the dishwater in a bucket via the drain hose.
The filter assembly was cleaned and a hoover positioned into it to remove any unseen food, etc. I hoovered any loose debris from the from the hose too.
Hose was connected to sink drain, ensuring no kinks, etc.
Tried a rinse cycle again and the same happened once more.

I would manually drain the dishwasher again and check the drain propellor/fins for blockages but every website says it should be behind the kick board and easy to access - my appliance doesnt have a kick board and the bottom panel looks a little too robust/secure, for it to be a service access point.

Any information / help will be greatly appreciated.
Thanks,
George.

GPBUTLER

Apologies -
Sites are leading to the drain fins being accessed through the plastic housing, the filter sits into but this is a moulded unit and doesn't have any screws or removable covers.
The drain/circulation pump should be behind the front kick-board but as I said, due to the appliance being integrated - the bottom front panel looks too robust and secure to a an access cover. It is metallic, held in by six screws and would have to be forced off. There are two plastic removable panels on it, took them off but there's only felt-lining behind them.

Again, any help would be greatly appreciated.
Cheers,
George.

GPBUTLER

Managed to fix the problem and it's back working as normal again.
Small piece of cable tie in the drain fin housing was the culprit.
Should anyone need detail on how it was fixed - send PM.

Cheers...George.