gas or aeg buffer

Untamedlemon

Hello all, im wondering whether these buffer tubes are for a gas m4 or aimply a different type of aeg

Untamedlemon

Second buffer:

Jsmurff

They look like AEG buffers to me but I could be wrong the two short groves would line up with the small tube that sticks out the backside of an AEG receiver

Untamedlemon

They fit on a receiver all right but there isnt any way to keep it in place with the screw kinda like a hybrid buffer tube!!

Jsmurff

Do you have the plate washer that sits inside the tube? It acts like a clamp holding the stock tube to the receiver if you do and it still wobbles then the screw may be too long but I have never heard of a hybrid stock tube

Untamedlemon

There was never any washer and I know theres no hybrid buffer.....just joking!!!!

T4RGET

they're both AEG buffer tube, or stock tubes is probably a more accurate name

You need this, the little semi-circle under the buffer tube with the hole in it. The screw in the picture fits through that washer and then attaches to the back of the gearbox keeping the buffer tube one. You can get those washer in full circles but the semi-circular ones are used for rear wired gearboxes.

http://shop.ehobbyasia.com/madbull-ace-m4-acu-stock-tube.html

Hope it helps .

Untamedlemon

T4RGET wrote: »

they're both AEG buffer tube, or stock tubes is probably a more accurate name

You need this, the little semi-circle under the buffer tube with the hole in it. The screw in the picture fits through that washer and then attaches to the back of the gearbox keeping the buffer tube one. You can get those washer in full circles but the semi-circular ones are used for rear wired gearboxes.

http://shop.ehobbyasia.com/madbull-ace-m4-acu-stock-tube.html

Hope it helps .

Thanks