Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

husqvarna cth151

  • 19-11-2011 11:21pm
    #1
    sam ford
    Registered Users, Registered Users 2 Posts: 77 ✭✭


    hi, a ride on mower[hydrostatic drive] not going into gear when you put the gear lever into position, just a kind of growling sound ,same in forward or reverse,any ideas,or any expert[husqvarna] in the south westmeath area,


Comments

  • #2
    Solnskaya
    Closed Accounts Posts: 1,463 ✭✭✭Solnskaya


    Checked the throw is adjusted correctly on the selector linkages? Jack up the back, disconnect the linkage and try putting it into drive/reverse by hand. The wheels should go into drive-if they do, your linkage has shifted and needs winding in/out a bit. Also check the fluid levels in the transaxle, if it has been run dry, it may be fecked-head along to Paul Coyne(Kinnegad) and get him to have a look, you can find him in the yellow pages, he specialises in motorbikes and husky equipment and is very sound. He is also rather good at making quads do what God intended again.:)


  • #3
    gregmarah
    Registered Users, Registered Users 2 Posts: 105 ✭✭gregmarah


    your brake is stuck , simple as , follow the linkage back to the brake wheel on the transaxle and spray wd40 on that area, while getting someone to keep pressing brake on and off .....seen it many many times over the years


Advertisement