KJW M700 External Air Rig

Leftyflip

Right - as many of you know, that rifle is horribly inconsistent and a fecker to get under 1J reliably. So I'm opting for an external HPA rig - anyone done anything similar before? There's two methods I've seen, one is where all of the components are put inside the stock, but option two seems a bit easier and less permanent, where there are couplings put into the mag and then run to a HPA canister and a regulator.

So, who's done it before or knows what bits I need? I've done a lot of trawling but haven't found much in the way of what I need.

Puding

added an internal co2 rig to a gas aw338 in the past, just a case of drilling an accurate hole in the mag to fit a nipple attachment, all i would advice is to pick a rig with two regulators for more reliable performance

external rig can give you a little more freedom in terms of power source and lower price but have the downside of well being external, not looking good and getting court on things

Leftyflip

Puding wrote: »

added an internal co2 rig to a gas aw338 in the past, just a case of drilling an accurate hole in the mag to fit a nipple attachment, all i would advice is to pick a rig with two regulators for more reliable performance

Any recommendations Pud?

Puding

picked it up from a small shop i found on arnies ( check out their snipers section i has a very in-depth thread on external rigs ) sold by own one last year, will see if i can dig the link up