Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

UBR Stock installation

  • 05-10-2011 3:33pm
    #1
    F.U.B.A.R
    Closed Accounts Posts: 2,638 ✭✭✭


    howdy folks was messing around with the stock and sort of found a problem :confused:
    on the inside of the buffer there is a short raised are where you should be using a spacer to install the stock but the posts that I have seen on loads of receivers reach beyond this raised area :(
    is there a separate installation kit I have to get or do I have lob a bit off the end of the post?


Comments

  • #2
    THE MINDER
    Registered Users, Registered Users 2 Posts: 1,147 ✭✭✭THE MINDER


    Cut the post:)


  • #3
    F.U.B.A.R
    Closed Accounts Posts: 2,638 ✭✭✭F.U.B.A.R


    off a madbull barret body??? I wouldnt dare!

    seriously I wouldnt trust meself with a saw:D
    I was looking at a few videos and they say you can get a kit for it but the search is futile :(


  • #4
    Alan b.
    Registered Users, Registered Users 2 Posts: 511 ✭✭✭Alan b.


    Get some pics up


  • #5
    F.U.B.A.R
    Closed Accounts Posts: 2,638 ✭✭✭F.U.B.A.R


    Hmm not sure i can fully capture the problem with my camera phone but I can draw some up tomorrow :) yano basic line drawings and such


Advertisement