30 mm scope mounts

adam_newe

looking for 2 x 30mm scope mounts to fit a brno mod2. ( think its the same as a 452)

tell me a price and any other info and il get back to you

i can post aswell

fodda

I have brand new in packet Hawke 2 piece Match Mounts .... double screw to fit 9mm-11mm (3/8") rail ... Medium

Anygood????

adam_newe

yeah there 30 mm yeah?

how much you looking for them?

fodda

Before i tell you, i bought these for my 452 and they didnt lift the scope high enough to clear the front iron site, so is your front iron site detachable or fixed?

adam_newe

awh its fixed i think

fodda

What scope you got 40mm 50mm or 56mm front lens?

adam_newe

its. a 6-24x50 so its a 50mm front lens

fodda

Can you show me the model of your gun or one with same kind of front site from the internet......try the cz website.

Reason for asking is i had to get extra high mounts to clear front non-detachable iron site.

Is it this type of iron site http://www.czub.cz/en/catalog/80-rimfire-rifles-cz/MS/CZ_452-2E_ZKM_LH_LUX.aspx

adam_newe

yes its that one are you talking about the tip of the barrel sight?

fodda

adam_newe wrote: »

yes its that one are you talking about the tip of the barrel sight?

No the one near where the scope fits, tip of the barrel one doesnt matter.

adam_newe

righ well thats the same sight exactly then

fodda

Well if it is and that site wont come off then you need "extra high mounts"and this took me hours of searching and great expense to suss this out.

The reason is the scope wont be able to come far enough back to you for the eye relief.

My scope is a 56mm lens and i tried high mounts but they were still to low.

The little drawback is, i had adjustable extra high mounts as it has been found that if your mounts are too high the rifle will not zero with the scope, so by having adjustable mounts you can overcome this by raising the back mount.

I dont think you should have that problem though as i didnt have to adjust mine.

The other way around it is by going for a 40mm lens scope which will not interfere with the iron site and will be able to positioned far enough back towards you for the eye relief, or a longer body length scope. Extra high mounts have an extra 2 screws per mount which allows you to raise them a few mm even higher if required, or raise just one to angle the scope to zero the rifle with the scope.

My scope is a 6-24 x 56 Hawke........different makes of scopes are entirely different in body length etc, but this even with these extra high mounts only clears the iron site by about 2-3mm and adjustment backwards and forwards is restricted by the length of the scope and the cartridge eject port, so everything was working against me.

Hope this helps:)

ianoo

had the same problem with my cz 452 ,solved it by getting the offending rear sight base "machined off "....problem solved and can use lower mounts

ian

Feidhlim Dignan

adam ithink it will fit, the objective lense will be out infront of the rear sight base or at least it was when i had it on my 452

http://www.boards.ie/vbulletin/showthread.php?t=2056292214

adam_newe

hi guys

was too confused and worried about weather or not they would fit so went to courtlough and picked up a nice set there

thanks for the interest