Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Takedown guide for A&K SVD

  • 11-10-2009 8:30pm
    #1
    FunkBlaster87
    Registered Users, Registered Users 2 Posts: 367 ✭✭


    Would someone be so kind as to put up a take down guide for the SVD. Or failing that tell where the hop up is located. :confused:

    Cheers


Comments

  • #2
    Puding
    Registered Users, Registered Users 2 Posts: 6,261 ✭✭✭Puding


    Puding wrote: »
    Flip the small level at the back of the receiver where it joins the stock, this will allow the top cover to come off, you will then need to pull back the bolt cover, the hop up is a small grub screw (see the pictures below)

    3722141706_fc343891ca-1.jpg

    should help you out :)


  • #3
    FunkBlaster87
    Registered Users, Registered Users 2 Posts: 367 ✭✭FunkBlaster87


    Ah cheers for that. Would you recommend replacing the rubber or is it good stock.


  • #4
    Puding
    Registered Users, Registered Users 2 Posts: 6,261 ✭✭✭Puding


    the stock accuracy on the a&k svd is very high and the hop up seems rather good, its like the madbul shark with two points of contact on the bb, i would to be honest leave it as stock


  • #5
    FunkBlaster87
    Registered Users, Registered Users 2 Posts: 367 ✭✭FunkBlaster87


    Cheers puding. Much appreciated. Hmmm now to un-ghille it.


Advertisement