Advice on Inset Stoves

Copper1

Hi,

Any advice on this would be very welcome.

I have a relatively new house, built in the last 5 years. I want to get a multi fuel stove and install it in an existing (open type) fireplace. The installer tells me that some structural work will be required - remove the fireback, remove the fireplace etc to see how much space is available. So far so good.

Now my question is about the need for a flue liner - do I need one? I have read that some manufacturers say that a liner is always required, but a number of different installers and shops have told me that a liner is not required in a new chimney. For me its not a question of cost, if one is needed I will get one, but I am getting conflicting advice from different sources.

Can anyone clear this up?

Thanks,

Copper1

Whaaat? I got an Esse 300 installed last year into an existing opening. You DO NOT NEED to remove fireback/fireplace/line the chimney etc. He must be trying to make work for himself. Now, if you had to install the Esse 350 which has a bigger firebox, then yes you would have to remove the fireback but thats all.

fmcc

Copper as was said above some inserts need the fireback out other dont but unless you need to change the insert part of the fireplace there should be no need to take the fireplace itself down. In a new house I still favour the cementing in or adapter and liner method as being both easier and cheaper but for peace of mind I can't fault the liner system if your willing to spend the extra amount required. Plenty of info about insets on our blog but you'll have to go through the contact info on my profile to get there. Give me a pm or post here again if you have any specific questions.

Copper1

Thanks for that.