KJW Sig P226 mag broken - help needed!

Mervenut

I dropped my mag and the plastic piece at the top, above the follower has broken so that bbs shoot out of their own accord under pressure from the spring. Superglue didn't sem to fix it, can the piece be replaced or do i need to buy a new mag (would prefer not to have to shell out €30 for a new one!)

DeBurca

I think this is the part you want

http://shop.ehobbyasia.com/upgrade-part/parts-upgrade-pistol/magazine-parts/action-magazine-lip-for-marui-kjw-p226-gbb.html

Mervenut

Thanks for that DeBurca, i'll order that today! Do you know if it is easy to fit as i don't see an easy way to disassemble the mag?

Any help appreciated as I'm a total Nooobb!

DeBurca

there is a small pin about 3mm in diameter near the top of the mag.
you will need to remove this pin
it is quiet tight you will need a pin punch and a hammer
dont go overboard with the hammer
if you dont have a pin punch a small nail might do
be firm but gentle it should only take 5-10 mins in total
you will also have to transfer the rubber seal from the old part to the new one
hope this helps

Mervenut

A BIG help, thanks DeBurca!

Mervenut

DeBurca wrote: »

hope this helps

Thanks, part arrived and replaced as you recommended! Thanks DeBurca!