How do I access the Sky installation menu?

Redsoxfan

Trying to see if my phone line connection is working-but I cannot find the menu to test on the Sky box-have tried a search but couldn't find anything (that worked).

Cheers.

Tony

Try services, system test

Redsoxfan

Can't seem to see the System Test option under Services-I'm pretty sure it was visible under the 'old' Sky + menus.

steveon

To access Hidden installers menu..

Press services
press 4
press 0,1 then select

To test telephone line..

press services
press 4
press 7

Redsoxfan

steveon wrote: »

To test telephone line..

press services
press 4
press 7

This brings me to Adult Movies!

It must be the new setup as I remember being able to access these options as you describe above previously.

steveon

What kind of sky box do you have???

If its a HD box with the new software then the installer menu is accessed by

Pressing
'Services 0 0 1 Select'

Redsoxfan

steveon wrote: »

What kind of sky box do you have???

If its a HD box with the new software then the installer menu is accessed by

Pressing
'Services 0 0 1 Select'

Sorry-it's a Thompson HD box, September 2006.

When I press 'Services 0 0 1 Select' I get the following options

Setup
Default TRP
Telephone (which has the dialling prefix and the tone type)
RF Out
Tuning
New Install
Rebuild
System Reset

But I can't see the 'Telephone Test' option in any of these menus (I'm not sure I should be messing with the 'New Install' menu?)

steveon

Havent a HD box in front of me at moment so not too sure where the test is but if you do the new installation it will do a callback and this will check the line for you. Wont do any damage to your subcription so dont worry.

Alternatively if u unplug the box with the telephone attached it will display an error message telling you to plug into an active phoneline ...this will only be visible if its not detecting the phoneline however it wont tell if it is able to do a callback

Redsoxfan

steveon wrote: »

Havent a HD box in front of me at moment so not too sure where the test is but if you do the new installation it will do a callback and this will check the line for you. Wont do any damage to your subcription so dont worry.

Tried this and got a message 'No Default Transponder Detected' and then everything went blue.....so I unplugged the box and it restored the picture, I guess I will leave well enough alone!

Thanks for your assistance.

Tony

Just checked and its now on the bottom of the "signal page" under "settings" on the new EPG