Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Zeroing Scope

Comments

  • Registered Users, Registered Users 2 Posts: 7,182 ✭✭✭Genghiz Cohen


    I'm unsure about the distance, but one of the best ways to zero a scope is to hold it with a vice so that it can't move (without damaging it OFC) then fire a few rounds into a paper target, then adjust the scope to the center of the group of bbs.


  • Banned (with Prison Access) Posts: 11,001 ✭✭✭✭Masada


    and make sure the hopup is set as straight as possible before ya do it, otherwise it'll be way off when yor ajusting the scope.,


  • Registered Users, Registered Users 2 Posts: 198 ✭✭sean1ucc


    Dere are no iron sights on the rifle though so jus look for swerving of the bb's den yea?? and when you say clamp the scope presumably its mounted on the gun!?


  • Registered Users, Registered Users 2 Posts: 7,182 ✭✭✭Genghiz Cohen


    sean1ucc wrote: »
    Dere are no iron sights on the rifle though so jus look for swerving of the bb's den yea?? and when you say clamp the scope presumably its mounted on the gun!?

    No clamp the gun with the scope mounted.
    Fire off a few bbs.
    adjust the crosshair to the center of the group.

    Swerving doesn't make to much of a difference as long as all the bbs go the same way.


  • Registered Users, Registered Users 2 Posts: 954 ✭✭✭MacAonghusa


    when i had a rifle years ago i just picked the range I was more often than not shooting at, 25m targets, and zeroed it for that. Just needed to aim higher or lower if the target was closer/further away ... not that it will make much difference unless you're shooting over a broad range.

    I think.


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 198 ✭✭sean1ucc


    Ah rite wel I dont have a clamp so that stuffs that plan!!


  • Banned (with Prison Access) Posts: 11,001 ✭✭✭✭Masada


    a work mate? a table and a load of cr*p keeping the gun steady?
    you dont really need to go through all that with an airsoft gun though, just use a card board box and get some distance between ya. ,fire at a mark on it using the scope and see where it hits, if its too high just turn the scope down a litle and try again.,


  • Registered Users, Registered Users 2 Posts: 198 ✭✭sean1ucc


    Student accommadation you see, could always do it out my window the other block is about 50 yds away:p (only joking by the way!!)


Advertisement