Setting up my rack (Pre and power amp only)

Yakult

So it occured to me, I have 3 imputs for different voicings on my mesa 2:90.
How do I link them up or do they act as imputs just ling going straight into "imput"?

Picture: (Is this set up right? And of course a speaker cable (I know that much haha)

Voodu Child

You've only got two inputs for the 2:90 - A and B

These correspond to the left and right hand sides of the amp, and you've got A and B volume controls on the front.

All the other inputs are relay triggers which the Mesa Triaxis uses to control the 2:90 for various different sounds. Im sure they respond to tip-to-ground logic so you could use a basic latching footswitch to control them if you wanted to experiment with different sounds.

I'd also strongly recommend you read the manuals (can be downloaded from mesaboogie.com) before using either the pre or the power amp. Lots of very valuable tips and precautions.

Yakult

^Ok that explains alot!

So the way I have it there in the picture is correct yesum?

Im downloading it now!

Voodu Child

Yeah, the way you're doing it is fine.

Like i say, the 3 other inputs are just logic switches, they're either on or off. They don't carry any musical signal.

I see you've only got one side in use. Im sure i've mentioned this already, but it's very important you know what you're doing when operating in mono like this. The manual should have the precautions, and they are also in an article or faq somewhere on the website.

Apart from that, yeah, just read the manuals for tips, and enjoy, obviously

Yakult

yeah have the side Im not using rolled down to 0 lol!