Help for a computer dummy

nacho libre

Hello,

sorry if this post in the wrong place. I'm new here so this issue may well have been addressed before, sorry for that too.

Here is my problem:
I have a zyxel router from Esat BT, I keep getting a yellow face/icon whilst using a bit torrent clinet(azureus in my case). I have tryed using different port numbers but each time I still get a nat error when i run the test. I read something about port forwarding as a solution to it but in the router settings there seems to be no icon for port forwarding.

this is what i see:

Site Map:
.....................................................

Wizard Setup


Advanced Setup
Password
LAN
Wan
NAT
Security
Dynamic DNS
Time and Date
Remote Management
UPnP

Maintenance

DHCP Table
System Status
Any IP Table
Diagnostic
Firmware
Configuration


Is there something i need to change in one of these settings to resolve the problem?


any help would be greatly appreciated. Thank you.

Thomas_S_Hunterson

It's in NAT, you have to set up port forwarding for the port you are using, so that if forwards communications to the IP of the computer you are using